South Bend Lathe, Heavy 10

South Bend Heavy 10 Toolroom Lathe Just Arrived!

SOLD !

We just acquired a nice little 10″x 24″ South Bend Heavy 10 Toolroom Lathe last week. It came out of a NASA machine shop and has been well maintained. It was built new in 1968 by South Bend and has hardened bedways, taper attachment, 3 jaw chuck, 5C collet drawtube and steady and follow rests.

Just in from NASA this nice Heavy 10 South Bend Toolroom Lathe

Perfect Lathe for Gunsmiths!

These South Bene Heavy 10 toolroom lathes are very popular with gunsmiths and do an exceptional job. Besides what was previously mentioned, it has the 1-3/8″ spindle bore, a micrometer stop, thread dial and tailstock. It is mounted on the South Bend sheet metal stand. The machine is wired for 230Volt 3Phase electrics.

These Heavy 10 lathes were manufactured by South Bend from the 1930s through the 1990s. This lathe was built in the US and shows the typical

We have posted specs and photos of this lathe and you can find it listed in our Engine Lathes section of the website. If you are in the market for a nice Heavy 10 South Bend Lathe, this will meet your needs. Give us a call at 817-481-6528 and make an appointment to come in and inspect it under power.